Isdn Switch-Type [Basic-5Ess | Basic-Dms | Basic-Net3 | Basic-Ni] - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide

isdn switch-type [basic-5ess | basic-dms | basic-net3 | basic-ni]

Use the isdn switch-type command to specify the ISDN signaling type configured on the Basic Rate ISDN
(BRI) interface. The type of ISDN signaling implemented on the BRI interface does not always match the
manufacturer of the Central Office switch. Use the no form of this command to return to the default value.
Syntax Description
basic-5ess
basic-dms
basic-net3
basic-ni
Default Values
By default, the ISDN signaling type is set to National ISDN-1.
Functional Notes
The isdn switch-type command specifies the type of ISDN signaling implemented on the BRI interface,
not the manufacturer of the Central Office switch. It is quite possible to have a Lucent Central Office switch
providing National ISDN signaling on the BRI interface.
Usage Examples
The following example configures a BRI interface for a circuit with Lucent 5ESS (custom) signaling:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#isdn switch-type basic-5ess
5991-2114
Specifies Lucent/AT&T 5ESS signaling.
Specifies Nortel DMS-100 custom signaling. The basic-dms signaling type is not
compatible with proprietary SL-1 DMS signaling.
Specifies Net3 Euro-ISDN signaling.
Specifies National ISDN-1 signaling.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
585