HP ProCurve 7102dl Reference Manual page 190

SROS Command Line Interface Reference Guide
show frame-relay fragment [interface frame-relay <port.sublink>]
Use the show frame-relay fragment command to display FRF.12 statistics for Frame Relay sublinks
enabling FRF.12 fragmentation.
Syntax Description
interface frame-relay <port.sublink>
Default Values
No default value necessary for this command.
Usage Examples
The following are sample outputs from various show frame-relay fragment commands:
ProCurve>enable
ProCurve#show frame-relay fragment
interface dlci
fr 1.1 17
fr 1.2 18
ProCurve>enable
ProCurve#show frame-relay fragment frame-relay 1.1
DLCI = 17 FRAGMENT SIZE = 100
rx frag. pkts
rx frag. bytes
rx non-frag. pkts
rx non-frag. bytes
rx assembled pkts
rx assembled bytes
dropped reassembling pkts
rx out-of-sequence fragments
rx unexpected beginning fragment
5991-2114
Optional. Displays detailed FRF.12 statistics for the specified
Frame Relay sublink (if FRF.12 is enabled on that sublink).
frag_size rx_frag
100 46
200 42
46 tx frag. pkts
4598 tx frag. bytes
18 tx non-frag. pkts
1228 tx non-frag. bytes
23 tx pre-fragment pkts
5478 tx pre-fragment bytes
0 dropped fragmenting pkts
0
0
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
tx_frag
48
21
48
4724
28
1960
34
6324
0
dropped_frag
0
0
188