HP ProCurve 7102dl Reference Manual page 928

SROS Command Line Interface Reference Guide
frame-relay fragment <threshold>
Use the frame-relay fragment command to set the FRF.12 fragmentation threshold. Use the no form of
this command to erase the configured threshold.
Syntax Description
<threshold>
Default Values
No default value is necessary for this command.
Functional Notes
For Frame Relay fragmentation to take effect, rate-limiting must be enabled by setting the committed burst
rate and excessive burst rate. See
be <excessive burst value>
Usage Examples
The following example enables FRF.12 fragmentation on a sublink:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#frame-relay bc 64000
ProCurve(config-fr 1.16)#frame-relay be 16
ProCurve(config-fr 1.16)#frame-relay fragmentation 100
The following example disables FRF.12 fragmentation on a sublink:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#no frame-relay fragment
5991-2114
Specifies the fragmentation threshold. Valid fragmentation thresholds are greater
than or equal to 64 and less than or equal to 1600.
frame-relay bc <committed burst value>
on page 925 for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Sub-Interface Config Command Set
on page 924 and
frame-relay
926