HP ProCurve 7102dl Reference Manual page 10

SROS Command Line Interface Reference Guide
Shortcut Description
<Ctrl> + A Jump to the beginning of the displayed command line. This shortcut is helpful when using the
no form of commands (when available). For example, pressing <Ctrl + A> at the following
prompt will place the cursor directly after the #:
ProCurve(config-eth 0/1)#ip address 192.168.55.6
<Ctrl> + E Jump to the end of the displayed command line. For example, pressing <Ctrl + E> at the
following prompt will place the cursor directly after the 6:
ProCurve(config-eth 0/1)#ip address 192.168.55.6
<Ctrl> + U Clears the current displayed command line. The following provides an example of the
<Ctrl + U> feature:
ProCurve(config-eth 0/1)#ip address 192.168.55.6
here)
ProCurve(config-eth 0/1)#
auto finish You need only enter enough letters to identify a command as unique. For example, entering
int t1 1/1
parameters for the specified T1 interface. Entering
but is not necessary.
Performing Common CLI Functions
The following table contains descriptions of common CLI commands.
Command
do
no
copy running-config startup-config
5991-2114
at the Global configuration prompt provides you access to the configuration
Description
The do command provides a way to execute commands in
other command sets without taking the time to exit the
current and enter the desired one. The following example
shows the do command used to view the Frame Relay
interface configuration while currently in the T1 interface
command set:
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#do show
interfaces fr 7
To undo an issued command or to disable a feature, enter
no
For example:
no shutdown t1 1/1
When you are ready to save the changes made to the
configuration, enter this command. This copies your
changes to the unit's nonvolatile random access memory
(NVRAM). Once the save is complete, the changes are
retained even if the unit is shut down or suffers a power
outage.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Performing Common CLI Functions
interface t1 1/1
before the command.
(Press <Ctrl + U>
would work as well,
8