HP ProCurve 7102dl Reference Manual page 750

SROS Command Line Interface Reference Guide
Default Values
<administrative distance>
client-id
hostname <"string">
Functional Notes
Dynamic Host Configuration Protocol (DHCP) allows interfaces to acquire a dynamically assigned IP
address from a configured DHCP server on the network. Many Internet Service Providers (ISPs) require
the use of DHCP when connecting to their services. Using DHCP reduces the number of dedicated IP
addresses the ISP must obtain. Consult your ISP to determine the proper values for the client-id and
hostname fields.
Usage Examples
The following example enables DHCP operation on the ATM sub-interface 1.1:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip address dhcp
The following example enables DHCP operation on the virtual ATM sub-interface (labeled 1.1) utilizing
hostname procurve and does not allow obtaining a default route, domain name, or nameservers. It also
sets the administrative distance as 5:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip address dhcp hostname "procurve" no-default-route no-domain-name
no-nameservers 5
5991-2114
By default, the administrative distance value is 1.
Optional. By default, the client identifier is populated using the following formula:
TYPE: INTERFACE SPECIFIC INFO : MAC ADDRESS
Where TYPE specifies the media type in the form of one hexadecimal byte
(refer to hardware-address <hardware-address> <type>
detailed listing of media types) and the MAC ADDRESS is the Media Access
Control (MAC) address assigned to the first Ethernet interface in the unit in
the form of six hexadecimal bytes. (For units with a single Ethernet interface,
the MAC ADDRESS assigned to Ethernet 0/1 is used in this field).
By default, the hostname is the name configured using the Global Configuration
hostname command.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
on page 1414 for a
748