HP ProCurve 7102dl Reference Manual page 615

SROS Command Line Interface Reference Guide
tdm-group <group number> timeslots <1-31> speed [56 | 64]
Use the tdm-group command to create a group of contiguous channels on this interface to be used during
the bind process. See bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 1431 for related information.
Caution
Changing tdm-group settings could result in service interruption.
Syntax Description
<group number>
timeslots <1-31>
speed [56 l 64]
Default Values
By default, there are no configured TDM groups.
Usage Examples
The following example creates a TDM group (labeled 5) of 10 channels at 64 kbps each:
ProCurve(config)#interface e1 1/1
ProCurve(config-e1 1/1)#tdm-group 5 timeslots 1-10 speed 64
5991-2114
Identifies the created TDM group by numerical label (Range: 1 to 255).
Specifies the channels to be used in the TDM group. This can be entered as a
single number representing one of the 31 E1 channel timeslots or as a contiguous
group of channels. (For example, 1-10 specifies the first 10 channels of the E1.)
Optional. Specifies the individual channel rate on the E1 interface to be 56 or 64 kbps.
The default speed is 64 kbps. 56 kbps operation is not available on all E1 interfaces.
Refer to the Quick Start Guide provided with your E1 module to determine whether
56 kbps is valid.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
E1 Interface Configuration Command Set
613