HP ProCurve 7102dl Reference Manual page 580

SROS Command Line Interface Reference Guide
bonding txdeq-timer <seconds>
Use the bonding txdeq-timer command to specify the value (in seconds) for the network delay
equalization timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txdeq-timer value is set to 50 seconds.
Usage Examples
The following example defines a bonding txdeq-timer value of 80 seconds:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#bonding txdeq-timer 80
5991-2114
Specifies the number of seconds the endpoint allots for attempting to equalize the
network delay between bearer channels before considering the bonding
negotiation a failure.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
578