HP ProCurve 7102dl Reference Manual page 193

SROS Command Line Interface Reference Guide
show interfaces <interface>
Use the show interfaces command to display configuration parameters and current statistics for all
interfaces (or a specified interface). Variations of this command include the following:
show interfaces <interface>
show interfaces <interface> performance-statistics
show interfaces <interface> performance-statistics <x-y>
show interfaces <interface> performance-statistics total-24-hour
show interfaces <interface> realtime
show interfaces <interface> verbose
show interfaces <interface> version
Note
Not all subcommands apply to all interfaces. Type show interfaces <interface> ? for a list
of valid subcommands for the specified interface.
Syntax Description
<interface>
performance-statistics
performance-statistics <x-y>
performance-statistics total-24-hour Optional. Displays the current 24-hour totals and the past seven
Note
Note: If you want to display the 24th interval, enter (for example) show interface t11/1
performance-statistics 24-24. Entering show interface t1 1/1 performance-statistics 24
results in displaying the 24-hour statistics. Any number other than 24 (between 1 and 96)
results in the correct display of the selected interval (e.g., show interface t1 1/1
performance-statistics 4 shows the fourth interval).
realtime
verbose
version
5991-2114
Specifies an interface in the format <interface type [slot/port |
slot/port.sub-interface id | interface id | interface id.sub-interface
id]>. For example, for a T1 interface use t1 0/1; for an Ethernet
sub-interface, use eth 0/1.1; for a PPP interface, use ppp 1; and
for an ATM sub-interface use atm 1.1. Type show interfaces ?
for a complete list of valid interfaces.
Optional. Displays the current 15-minute interval, the current
24-hour totals, and all 96 stored intervals.
Shows the current 15-minute interval, the current 24-hour totals,
and all intervals from x through y. This command is basically the
same thing as the performance-statistics command with the
added function of allowing you to specify a particular interval (or
range of intervals) to display rather than displaying all 96.
24-hour intervals.
Displays full-screen output in real-time. Refer to the Functional
Notes below for more information.
Displays detailed configuration information on the terminal screen
(versus only the non-default values).
Optional. Displays current version information (e.g., model and
list number, software version, etc.) for the T1 interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
191