HP ProCurve 7102dl Reference Manual page 717

SROS Command Line Interface Reference Guide ATM Interface Config Command Set
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Usage Examples
The following example enables SNMP on the ATM interface:
ProCurve(config)#interface atm 1
ProCurve(config-atm 1)#snmp trap
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 715