Show Ip Ospf - Dell PowerConnect W-7200 Series Reference Manual

show ip ospf

show ip ospf [database]|[debug route]|[interface tunnel|vlan <id>]|[neighbor]| [redistribute]
|[subnet]
Description
Display statistics and configuration information for the Open Shortest Path First (OSPF) routing protocol.
Syntax
Parameter
database
debug route
interface tunnel|vlan <id>
neighbor
redistribute
subnet
Example
If you issue this command without any of the optional parameters described in the table above, the show ip ospf
command will display general router and area settings for the OSPF.
(host) (config-subif)# show ip ospf
OSPF is currently running with Router ID 123.45.110.200
Number of areas in this router is 1
Area 10.1.1.0
Number of interfaces in this area is 2
Area is totally stub area
SPF algorithm executed 0 times
The output of this command includes the following parameters.
Parameter
OSPF Router ID
Number of areas
Area
To display OSPF settings for an individual interface, you must specify a VLAN or tunnel ID number. The example
below displays part of the output of the show ip ospf interface vlan command.
1080 | show ip ospf
Description
Show database information for the OSPF protocol.
Show debugging information for OSPF routes.
Display the status of OSPF on an individual interface by specifying a tunnel or VLAN
ID number.
Display data for OSPF neighboring routers.
Display OSPF route distribution information.
Display the subnets manually added to the Subnet Exclude List via the
subnet exclude <addr> <mask>
Description
Verifies that OSPF is running and the router ID that OSPF is running on.
List the number of areas configured in the router.
Displays the Area ID followed by:
number of interfaces in the area
l
indicates if the area is a totally stub area
l
number of times the SPF algorithm has been executed
l
command.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
router ospf