Show Uplink-State-Group - Dell S4810 Reference Manual

show uplink-state-group

Display status information on a specified uplink-state group or all groups.
S4810
Syntax
show uplink-state-group [group-id] [detail]
Parameters
group-id
detail
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.2.3
Example
Dell# show uplink-state-group
Uplink State Group: 1 Status: Enabled, Up
Uplink State Group: 3 Status: Enabled, Up
Uplink State Group: 5 Status: Enabled, Down
Uplink State Group: 6 Status: Enabled, Up
Uplink State Group: 7 Status: Enabled, Up
Uplink State Group: 16 Status: Disabled, Up
Dell# show uplink-state-group 16
Uplink State Group: 16 Status: Disabled, Up
Dell#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface
disabled
Uplink State Group
Upstream Interfaces
Downstream Interfaces :
Uplink State Group
Upstream Interfaces
Downstream Interfaces : Te 13/0(Up) Te 13/1(Up) Te 13/3(Up) Te
1684
Displays status information on a specified uplink-state group
or all groups. The valid group-id values are from 1 to 16.
Displays additional status information on the upstream and
downstream interfaces in each group
EXEC
EXEC Privilege
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
: 1 Status: Enabled, Up
:
: 3 Status: Enabled, Up
: Gi 0/46(Up) Gi 0/47(Up)
Uplink Failure Detection (UFD)