Ipv6 Bgp Neighbor - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 bgp neighbor

ipv6 bgp neighbor
Creates or deletes a BGP peer relationship using IPv6 addresses.
ipv6 bgp neighbor ipv6_address
no ipv6 bgp neighbor ipv6_address
Syntax Definitions
ipv6_address
Defaults
By default, no BGP peers are configured in the BGP network.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete a BGP peer.
•
To establish a BGP session, the BGP peer should be reachable.
•
You must manually enable a BGP peer after creating it. A BGP peer is enabled using the
neighbor admin-state
•
Once created, a BGP peer must be assigned an autonomous system number using the
bor remote-as command.
•
Use update-source keyword to configure the IPv6 interface when link-local address is used as neigh-
bor address.
Examples
-> ipv6 bgp neighbor 2001::1
-> no ipv6 bgp neighbor 2001::1
Release History
Release 7.1.1; command was introduced.
page 19-212
The 128-bit IPv6 address of the new BGP peer.
command.
OmniSwitch CLI Reference Guide
BGP Commands
ipv6 bgp
ipv6 bgp neigh-
March 2011