Display Poe Interface Power - H3C S5120-SI Series Command Reference Manual

Status
Priority
CurPower
Operating Status
IEEE class
Detection Status
port(s) on
consumed
Remaining

display poe interface power

Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Field
1-6
Description
PoE state: enabled/disabled
enabled: PoE is enabled.
disabled: PoE is disabled.
Power priority of a PoE interface:
critical (highest)
high
low
Current power of a PoE interface
Operating state of a PoE interface
off: PoE is disabled.
on: Power is supplied for a PoE interface
normally.
power-lack: The
power of the PSE is not high enough to
supply power for a critical PoE interface.
power-deny: The PSE refuses to supply
power. The power required by the powered
device (PD) is higher than the configured
power.
power-itself: The external equipment is
supplying power for itself.
power-limit: The PSE is supplying a limited
power. The power required by the PD is
higher than the configured power and the
PSE still supplies the configured power.
PD power class defined by IEEE
Power detection state of a PoE interface:
disabled: The PoE function is disabled.
searching: The PoE interface is searching
for the PD.
delivering-power: The PoE interface is
supplying power for the PD.
fault: There is a fault defined in 802.3af.
test: The PoE interface is under test.
There is a fault other than defined in 802.3af.
pd-disconnect: The PD is disconnected.
Number of PoE interfaces that are supplying
power
Power consumed by the current PoE interface
Total remaining power of the system
guaranteed remaining