Display Poe Interface Power - H3C s3600 series Command Manual

Table 1-2 display poe interface command output description
Field
PORT INDEX
POWER
ENABLE
MODE
PRIORITY
STATUS

display poe interface power

Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Port type and port number.
Description
Use the display poe interface power command to view the power information of a specific port of the
switch. If the interface-type interface-number argument is not specified, the command displays the
power information of all ports of the switch.
Examples
# Display the power information of Ethernet 1/0/10.
<Sysname> display poe interface power Ethernet1/0/10
Port power
# Display the power information of all ports.
<Sysname> display poe interface power
PORT INDEX
Ethernet1/0/1
Port index
Power status on the port: ON/OFF
PoE enabled/disabled status on the port
PoE mode on the port:
signal: PoE through the signal cable
spare: PoE through the spare cable
PoE priority of the port:
critical: Highest
high: High
low: Low
PoE status on the port:
user command set port to off: PoE to the port is turned off by the
user
Standard PD was detected: A standard PD is detected
PD detection is in process: PDs are being detected
If the poe enable command is configured on a port, and the port is
not connected to a standard PD (for example, a PC),
" non-standard PD connected" will be displayed.
:12400 mW
POWER (mW)
0 Ethernet1/0/2
1-3
Description
PORT INDEX POWER (mW)
0