Safety During Maintenance And Repair - ABB IRB 1100 Product Manual

1.6 Safety during maintenance and repair

1.6.1 Safety during maintenance and repair
General
Corrective maintenance must only be carried out by personnel trained on the robot.
Maintenance or repair must be done with all electrical, pneumatic, and hydraulic
power switched off, that is, no remaining hazards.
Hazards due to stored mechanical energy in the manipulator for the purpose of
counterbalancing axes must be considered before maintenance or repair.
Never use the robot as a ladder, which means, do not climb on the controller,
manipulator, including motors, or other parts. There are hazards of slipping and
falling. The robot might be damaged.
Make sure that there are no loose screws, turnings, or other unexpected parts
remaining after work on the robot has been performed.
When the work is completed, verify that the safety functions are working as
intended.
Hot surfaces
Surfaces can be hot after running the robot, and touching these may result in burns.
Allow the surfaces to cool down before maintenance or repair.
Allergic reaction
Warning
Allergic reaction
Gearbox lubricants (oil or grease)
When handling oil, grease, or other chemical substances the safety information of
the respective manufacturer must be observed.
Warning
Hot oil or grease
Product manual - IRB 1100
3HAC064992-001 Revision: L
Description
When working with lubricants
there is a risk of an allergic reac-
tion.
Note
Take special care when handling hot lubricants.
Description
Changing and draining gearbox
oil or grease may require hand-
ling hot lubricant heated up to
90 °C.
© Copyright 2019-2022 ABB. All rights reserved.
1.6.1 Safety during maintenance and repair
Elimination/Action
Make sure that protective gear
like goggles and gloves are al-
ways worn.
Elimination/Action
Make sure that protective gear
like goggles and gloves are al-
ways worn during this activity.
Continues on next page
1 Safety
31