ABB IRB 1100 Product Manual page 80

3 Installation and commissioning
3.3.7 Installation of signal lamp (option)
Continued
3
4
Further information
Further information about the MOTORS ON/MOTORS OFF mode may be found in
the product manual for the controller.
Further information about how to set up I/O system may be found in Technical
reference manual - System parameters.
80
Action
For robots with OmniCore E line
Connect the lamp cable connector to the MON connector on the controller.
Note
The MON connector provides MON_LAMP output signals for use.
For more details, see chapter Descriptions for connectors in OmniCore product
manuals.
The lamp is now ready for use and is lit in MOTORS ON mode.
© Copyright 2019-2022 ABB. All rights reserved.
Product manual - IRB 1100
3HAC064992-001 Revision: L