ABB IRB 1100 Product Manual page 428

5 Repair
5.6.1 Replacing the housing
Continued
2
Continues on next page
428
Action
Make sure that:
• The hole on the cable protection tube is
aligned with the locking screw hole on the
gearbox.
• The cable protection tube surface is com-
pletely parallel with the pulley cover at one
side and with the flange at the other side.
© Copyright 2019-2022 ABB. All rights reserved.
Note
Holes to be aligned are shown in
the following figure.
xx1800003018
Surfaces to be paralleled are
shown in the following figures.
xx1800003019
xx1800003020
Product manual - IRB 1100
3HAC064992-001 Revision: L