ABB IRB 1100 Product Manual page 137

4
Removing the process hub
1
2
Product manual - IRB 1100
3HAC064992-001 Revision: L
Action
Disconnect the connectors.
• J2.C1
• J2.C2
Tip
Take photos of the connector and cable position
before disconnecting them, to have as a reference
when reconnecting.
Tip
The connector clip has to be pressed (1) and
pushed forward (2) to separate the J2.C2 (for
Ethernet cabling).
xx1800002943
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 123.
© Copyright 2019-2022 ABB. All rights reserved.
5.3.1 Replacing the upper cable package
Note
xx1800002501
Note
Continues on next page
5 Repair
Continued
137