ABB IRB 1100 Product Manual page 297

4
Removing the brake release button
Notice that the procedure differs depending on if the connector interface is located
either at the rear or at the bottom of the base.
1
2
Product manual - IRB 1100
3HAC064992-001 Revision: L
Action
Valid for cabling with bottom interface (option
3309-1)
Remove the base adapter.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 123.
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.4.2 Replacing the swing
Continued
Note
xx1800003056
Note
Continues on next page
297