ABB IRB 1100 Product Manual page 550

5 Repair
5.7.5 Replacing the axis-5 motor
Continued
Spare part
Gasket for process hub
Required tools and equipment
Equipment
Standard toolkit
Calibration tool box, Axis Calibra-
tion
24 VDC power supply
Sonic tension meter
Dynamometer
J5.C2 connector assembly tool
Required consumables
Consumable
Cable straps
Grease
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Continues on next page
550
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
© Copyright 2019-2022 ABB. All rights reserved.
Article number Note
3HAC065352-001 Used with protection class IP67
and protection type Clean Room.
Replace if damaged.
Article number Note
- Content is defined in section
Standard toolkit on page
3HAC074119-001 Delivered as a set of calibration
tools.
Required if Axis Calibration is the
valid calibration method for the
robot.
The tool box also includes a
unique calibration pin for IRB
1100 to be fitted to the tool flange
during calibration of axis 6.
- Used to release the motor brakes.
- Used for measuring the timing
belt tension.
- Used for measuring the timing
belt tension.
- Included in the special toolkit
3HAC071022-001.
Used to remove and refit the
J5.C2 connector, if the Ethernet
cabling is equipped.
Article number Note
-
3HAC029132-001 FM 222
Note
Note
Calibrating axis 6 always requires tools to
be removed from the mounting flange (also
for reference calibration) since the mount-
ing flange is used for installation of the
calibration tool.
757.
Product manual - IRB 1100
3HAC064992-001 Revision: L