11-066-170, 11-384-170 HCSS BM Tamper Failure RAP
11-066-170 The HCSS BM tamper 1 failed to clear the home sensor.
11-384-170 The HCSS BM tamper 1 is not at the home sensor.
Initial Actions
•
Check for a jam or other obstruction that could prevent the tamper mechanism from mov-
ing.
•
Check for damaged tamper components, PL 11.81.
Procedure
Enter dC330 code 11-384 Actuate the BM tamper 1 home sensor, Figure 1. The
changes.
Y
N
Go to Flag 1, check the sensor, Q11-384.
Refer to:
•
GP 11, How to Check a Sensor.
•
P/J556, BM PWB.
•
11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
•
BM PWB, PL 11.86 Item 10.
•
BM tamper 1 home sensor, PL 11.81 Item 1.
Enter dC330, code 11-066 to run the BM tamper 1 motor, MOT 11-066, Figure 1. The
runs.
Y
N
Go to Flag 2 and Flag 3, check the motor, MOT 11-066.
Refer to:
•
GP 10 How to Check a Motor.
•
P/J554, BM PWB.
•
11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
•
BM PWB, PL 11.86 Item 10.
•
BM tamper 1 motor, PL 11.81 Item 3.
The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.2. If neces-
sary install new components:
•
BM tamper 1 home sensor, PL 11.81 Item 1.
•
BM tamper 1 motor, PL 11.81 Item 3.
•
BM PWB, PL 11.86 Item 10.
Status Indicator RAPs
11-066-170, 11-384-170
display
motor
August 2007
2-472
BM tamper 1 motor,
MOT11-066
BM tamper 1 home sensor, Q11-384
Figure 1 Component location
WorkCentre 5687 Family