Sorting Based On Measured Result (Comparator Function); Setting Up Comparator Function; Turning On/Off Comparator Function; Setting Up Limit Range - Keysight E4981A Programming Manual

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Programming Manual
7 Sorting Based on Measured Result (Comparator
Function)
This chapter describes how to use the comparator function to perform sorting
based on the measured result.

Setting Up Comparator Function

Turning ON/OFF comparator function

To enable/disable the comparator function, use the following command:
•

Setting up limit range

Clearing (resetting) limit range
You can clear the ON/OFF state and the lower and upper limit values of all limit
ranges (BIN1 to BIN9 and the secondary parameter limit range) and the
ON/OFF state of AUX BIN to recover the factory-shipped default values (refer
to Operation Manual, Appendix C "Initial Setting").
To clear the limit ranges, use the following command.
•
:CALCulate1:COMParator[:STATe]
:CALCulate1:COMParator:CLEar
on page 187
on page 175