Busy Tone Disconnect - Avaya Communication Manager Administrator's Manual

Screen Reference
Answer Send (msec)
This field appears only if the Trunk Type field is dis and the trunk group Direction field is
incoming or two-way. Only TN2140 and TN2199 ports receive this timer.
Valid entries
10 to 2550 in increments of 10

Busy Tone Disconnect

The field appears when Enable Busy Tone Disconnect for Analog loop-start Trunks is y on
the System Parameters Country-Options screen.
Valid entries
y/n
Cama Outgoing Dial Guard (msec)
This field appears when Group Type is cama (the trunk group type used for emergency 911
service).
Valid entries
25 to 6375 in
increments of 25
Cama Wink Start Time (msec)
This field appears when Group Type is cama.
Valid entries
20 to 5100 in
increments of 20
1656 Administrator Guide for Avaya Communication Manager
Usage
Enter the duration of the answer signal pulse.
Usage
Enter y to allow Communication Manager to recognize a busy tone signal
as a disconnect on this trunk group.
Usage
Enter the minimum interval between the seizure acknowledgment on the
receiving server or switch and the outpulsing of digits by this server.
Usage
Specifies the duration (the wait-for-wink-to-end time) for a wink-start
CAMA trunk. The wink must begin before the Outgoing Seizure Response
timer expires.