Lldp Management Address List; Lldp Basic Tlvs Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Notification
Subtype
Admin State
IP Subtype
Action
Address
Click the Apply button to accept the changes made.
NOTE: The IPv4 or IPv6 address entered here should be an existing LLDP management IP

LLDP Management Address List

This window is used to view the LLDP management address list.
To view the following window, click L2 Features > LLDP > LLDP Management Address List, as shown
below:
The fields that can be configured are described below:
Parameter
Subtype
Click the Find button to locate a specific entry based on the selection made.

LLDP Basic TLVs Settings

Type-length-value (TLV) allows the specific sending information as a TLV element within LLDP packets.
This window is used to enable the settings for the Basic TLVs Settings. An active LLDP port on the
Description
Select to enable or disable the notification feature here.
Select the subtype of LLDP TLV(s). Options to choose from are MAC
Address, and Local.
Select the local LLDP agent and allow it to send and receive LLDP
frames on the port. Options to choose from are TX, RX, TX and RX,
and Disabled.
•
TX - The local LLDP agent can only transmit LLDP frames.
•
RX - The local LLDP agent can only receive LLDP frames.
•
TX and RX - The local LLDP agent can both transmit and
receive LLDP frames.
•
Disabled - The local LLDP agent can neither transmit nor
receive LLDP frames.
The default value is TX and RX.
Select the type of the IP address information to be sent. Options to
choose from are Default, IPv4 and IPv6.
Select this option to enable or disable the action field
Enter the IP address that will be sent.
address.
Figure 5-74 LLDP Management Address List Window
Description
Select the subtype. Options to choose from are All, IPv4 and IPv6.
160