Table of Contents
Advertisement
4 Configuration
Community String
Click Apply to make the configurations take effect.
Management > D-Link Discovery Protocol
For devices that support the D-Link Discovery Protocol (DDP), this page allows users to enable or disable
DDP, and configure the DDP packet report timer.
The fields that can be configured for D-Link Discovery Protocol are described below:
Item
D-Link
discovery
Protocol State
Report Timer
Click Apply to make the configurations take effect.
L2 Features > FDB > Static FDB > Unicast Static FDB
The Unicast Static FDB page allows user to view and configure the static unicast forwarding settings on the
Switch.
The fields that can be configured for Unicast Static FDB are described below:
Item
Port
VID
MAC Address
Click Apply to make the configurations take effect.
Click Delete All to delete all the entries found in the display table.
Specify the community string for the management host.
Figure 4.24 – Management > D-Link Discovery Protocol
Description
Specify to enable or disable the D-Link discovery protocol feature of
the Switch.
Configure the report timer of the D-Link Discover Protocol in
seconds. The values are 30, 60, 90, 120 or Never. The default is 30
seconds.
Figure 4.25 – L2 Features > FDB > Static FDB > Unicast Static FDB
Description
Allows the selection of the port number on which the MAC address
entered resides.
Enter the VLAN ID of the VLAN which the corresponding MAC
address belongs to.
Enter the MAC address to which packets will be statically forwarded
or dropped. This must be a unicast MAC address.
D-Link Smart Managed Switch User Manual
Table 4.10
Table 4.11
Table 4.12
2
2
3
3
Advertisement
Table of Contents
