Mirror Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

61. Mirror Commands

61-1 monitor session destination interface
This command is used to configure the destination interface for a port monitor session, allowing packets
on source ports to be monitored via a destination port. Use the no form of the command to delete a port
monitor session or remove the destination interface of the session.
monitor session SESSION-NUMBER destination interface INTERFACE-ID
no monitor session SESSION-NUMBER destination interface INTERFACE-ID
no monitor session SESSION-NUMBER
Parameters
session SESSION-NUMBER
interface INTERFACE-ID
Default
A session is a local monitor session without destination interfaces.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the destination interface for a local monitor session or the destination
interface on the destination switch for an RSPAN session.
Both physical ports and port channels are valid as destination interfaces for monitor sessions. For a
monitor session, multiple source interfaces can be specified, but only one destination interface can be
specified. An interface cannot be a source interface of one session and destination port of another
session simultaneously. An interface can be configured as the destination interface of multiple sessions,
but it can be a source interface of only one session.
This command is used to configure the destination switch of an RSPAN session. Also, use the monitor
session source remote vlan command to configure the VLAN that the monitored source packets are
tunneled to the switch from the remote site.
Example
This example shows how to create a port monitor session with the session number 1. It assigns a
physical port ethernet1/0/1 as the destination port and three physical source ports (ethernet1/0/2 to
ethernet1/0/4) as monitor source ports.
Switch# configure terminal
Switch(config)# monitor session 1 destination interface ethernet1/0/1
Switch(config)# monitor session 1 source interface ethernet1/0/2-4
Switch(config)#
61-2 monitor session destination remote vlan
Specifies the session number for the port monitor session. The valid
range is 1 to 4.
Specifies the destination interface for the port monitor session.
683