Chapter 63 Mirror Commands - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 63
create mirror group_id <value 1-4>
config mirror port <port> {[add | delete] source ports <portlist> [rx | tx | both]}
config mirror group_id <value 1-4> {target_port <port> | [add | delete] source ports <portlist> [rx |
tx | both] | state [enable | disable]}(1)
delete mirror group_id <value 1-4>
enable mirror
disable mirror
show mirror {group_id <value 1-4>}
63-1 create mirror group_id
Description
This command used to create a mirror group. If the mirror group has existed, do nothing and return
success.
Format
create mirror group_id <value 1-4>
Parameters
<value 1-4> - Enter the mirror group ID used here. This value must be between 1 and 4.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Create mirror group 3:
DGS-3620-28SC:admin# create mirror group_id 3
Command: create mirror group_id 3
Success.
DGS-3620-28SC:admin#
63-2 config mirror port
Description
This command is used to allow a range of ports to have all of their traffic also sent to a designated
port − where a network sniffer or other device can monitor the network traffic. In addition, you can
specify that only traffic received by, sent by or both is mirrored to the target port.
Mirror Commands
736