Ip Igmp Snooping Querier - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
used as source MAC of the report. If the VLAN has no IP address configured, then system MAC will be
used.
Example
This example shows how to enable IGMP snooping proxy-reporting on VLAN 1 and configure the proxy-
reporting message source IP to be 1.2.2.2.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-if)# ip igmp snooping proxy-reporting source 1.2.2.2
Switch(config-if)#
44-10

ip igmp snooping querier

This command is used to enable the capability of the entity as an IGMP querier. Use the no form of this
command to disable the querier function.
ip igmp snooping querier
no ip igmp snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. The interface must have IP address
assigned to start the querier. The system will return warning message if the VLAN has no IP address. If
querier is enabled, but IP address is removed, the querier will be stopped. If the system can play the
querier role, the entity will listen for IGMP query packets sent by other devices. If IGMP query message is
received, the device with lower value of IP address becomes the querier. If IGMP protocol is also enabled
on the interface, IGMP snooping querier state will be disabled automatically.
Example
This example shows how to enable the IGMP snooping querier on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping querier
Switch(config-vlan)#
44-11 ip igmp snooping query-interval
This command is used to configure the interval at which the IGMP snooping querier sends IGMP general
query messages periodically. Use the no form of the command to revert to the default setting.
540