CLI Command Reference
Port Configuration Commands
This section describes the commands you use to view and configure port settings.
interface
This command gives you access to the Interface Config mode, which allows you to enable or
modify the operation of an interface (port).
Format
Mode
auto-negotiate
This command enables automatic negotiation on a port.
Default
Format
Mode
no auto-negotiate
This command disables automatic negotiation on a port.
NOTE:
Format
Mode
auto-negotiate all
This command enables automatic negotiation on all ports.
Default
Format
Mode
no auto-negotiate all
This command disables automatic negotiation on all ports.
Format
Mode
description
Use this command to create an alpha-numeric description of the port.
Format
Mode
38
© 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
interface <slot/port>
Global Config
enabled
auto-negotiate
Interface Config
Automatic sensing is disabled when automatic negotiation is disabled.
no auto-negotiate
Interface Config
enabled
auto-negotiate all
Global Config
no auto-negotiate all
Global Config
description <description>
Interface Config