Mxg610S Setup Guide; Blade Server Preparation; Switch Module Installation - Dell MXG610s Setup Manual

Topics:
•

Blade server preparation

•

Switch module installation

• Serial connection
• Static IP addresses
• Optical transceivers and cabling installation
• Port-side LEDs
• Additional country-specific IEEE notices
Blade server preparation
Before you insert the switch module in the blade server chassis, meet the following
conditions:
• The blade server is powered up.
• The blade server chassis meets all its specific power requirements.
• The I/O module bay C1 or C2 is empty and ready to receive the switch module.
• If you are replacing an existing switch module, to maintain the proper cooling level in the
chassis, insert the replacement switch module within one minute.
Switch module installation
Insert the switch modules in the blade server chassis slots and check that the modules are
functioning properly.

MXG610s Setup Guide

MXG610s Setup Guide
2
5