Show Vlt Inconsistency - Dell S4810 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
Example
Dell# Dell(conf-if-vl-100)#show vlt detail
Local LAG Id Peer LAG Id Local Status Peer Status Active VLANs
------------ ----------- ------------ ------------
-------------
10
400,

show vlt inconsistency

Display run-time inconsistencies in the incoming interface (IIF) for spanned multicast routes.
S4810
Syntax
show vlt inconsistency ip mroute
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version 9.2(0.2)
Example
Dell#show vlt inconsistency ip mroute
Spanned Multicast Routing IIF Inconsistency
Multicast Route
---------------
(22.22.22.200, 225.1.1.2)
(*, 225.1.1.2)
Dell#
1726
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
10 UP
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the Z9000, S4810, and S4820T.
UP 100, 200, 300,
LocalIIF PeerIIF
---------- ---------
VLAN 5 VLAN 6
VLAN 15 te 0/5
Virtual Link Trunking (VLT)