Clear Ipv6 Ospf Process - Dell Force10 S4810P Reference Manual

null
Defaults Not configured.
Command Modes ROUTER OSPFv3
Command History
Version 9.1.(0.0)
Version 8.4.2.0
Usage
Before you enable IPsec encryption on an OSPFv3 interface, you must first enable OSPFv3
Information
globally on the router. You must configure the same encryption policy (same SPI and keys) on
each interface in an OSPFv3 link.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the
router.
Note that when you configure encryption for an OSPFv3 area with the area encryption
command, you enable both IPsec encryption and authentication. However, when you enable
authentication on an area with the area authentication command, you do not enable encryption
at the same time.
If you have enabled IPsec authentication in an OSPFv3 area with the area authentication
command, you cannot use the area encryption command in the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over an area-
level configuration. If you remove an interface configuration, an area encryption policy that has
been configured is applied to the interface.
To remove an IPsec encryption policy from an interface, enter the no area
spi
Related
ipv6 ospf
Commands
encryption
show crypto
ipsec policy

clear ipv6 ospf process

Reset an OSPFv3 router process without removing or re-configuring the process.
C-Series, E-Series, Z-Series, S4810
Syntax clear ipv6 ospf process
Command Modes
For SHA-1 authentication, the key must be 40 hex digits (non-
encrypted) or 80 hex digits (encrypted).
Causes an encryption policy configured for the area to not be
inherited on the interface.
Introduced on the S4810 and Z9000.
Introduced on the E-Series TeraScale.
number command.
Configure an IPsec encryption policy on an OSPFv3 interface.
Display the configuration of IPsec encryption policies.
• EXEC
• EXEC Privilege
area-id encryption
1213