Vlt-Peer-Lag Port-Channel - Dell S4810 Reference Manual

Version 8.3.8.0
Usage The VLT domain ID must be the same between the two VLT devices. If the domain
Information ID is not the same, a syslog message is generated and VLT does not launch.
Related show vlt
Commands value.

vlt-peer-lag port-channel

Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
S4810
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number
Defaults Not configured.
Command INTERFACE PORT-CHANNEL
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
1734
Introduced on the S4810.
— uses the show vlt brief command to display the delay-restore
Enter the respective vlt port-channel number of the peer
device.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Virtual Link Trunking (VLT)