Interface Management - Dell S4810 Reference Manual

interface management

Associates a management port with a management VRF.
S4810
Syntax
interface management
To delete the association between a management port and a management VRF,
use the no interface management command.
Defaults None.
Command VRF MODE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
Use this command to associate a management port with a management VRF.
Information
When you execute this command, the management ports corresponding to both
the ACTIVE unit as well as the STANDBY unit are associated with the management
VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
S4810 S6000
Syntax
maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit
warning-
threshold
1704
Introduced on the S-Series and Z-Series.
Maximum number of routes allowed in a VRF. Valid range is
from 1 to 16,000 (or maximum allowable for that platform if
smaller value).
Warning threshold value is expressed as a percentage of the
limit value. When the number of routes reaches the specified
percentage of the limit, a warning message is generated.
Valid range is 1 to 100. When warn-threshold is used, once
Virtual Routing and Forwarding (VRF)