Show Nas-Interface - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.2 Network Interface > show nas-interface

show nas-interface

This command displays information about the NAS interface that is registered in the ETERNUS DX.
If the NAS interface identifier is specified, information is displayed only for the specified NAS interface or
port. If the identifier is omitted, an overview of the NAS interface is displayed in a list.
■ Syntax
show nas-interface [-nas-if-number
■ Parameter
-nas-if-number
-port
nas-if-number
Optional. This parameter specifies the NAS interface number to be displayed. When the "-nas-
if-number" parameter is used, multiple numbers can be specified by inserting a hyphen (-) or a
comma (,) between them as a delimiter.
nas-if-number
NAS interface number
Optional. This parameter specifies the NAS port to be displayed. Only the NAS interface that is
assigned to the specified NAS port is displayed. Multiple ports can be specified by inserting a
hyphen (-) or a comma (,) between them as a delimiter.
Example: -port 000,001
For details, refer to "1.2.15 Host Interface Port Syntax" (page
A non-NAS port or a member port for bonding is ignored if specified.
port NAS port
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
port
] [-port ]
749
29).
P2X0-1210-05ENZ0