Fujitsu Eternus DX100 S3 User Manual page 763

Chapter 7 NAS Function Setting and Display
7.3 Network Interface Bonding > set nas-bonding
-mode
-hash-policy
■ Example(s)
The following example shows settings for assigning CM#1 CA#0 Port#0 to a master port and assigning CM#1
CA#0 Port#1 and CM#1 CA#1 Port#1 to member ports:
CLI> set nas-bonding -master-port 100 -member-port 101,111 -mode 1
The following example shows settings for adding CM#1 CA#0 Port#1 to the master port CM#1 CA#1 Port#1 as
a member port:
CLI> set nas-bonding -master-port 111 -member-port 101 -mode 2 -hash-policy L23
port2 port3
, ,...
Member port
Example: -member-port 100,101
Optional. This parameter specifies the bonding mode.
0 balance-rr
1 active-backup
2 balance-xor
4 802.3ad
5 balance-tlb
6 balance-alb
Optional. This parameter specifies the hash policy. If omitted, this parameter is set to L2 or
equivalent.
This setting is only enabled when "-mode" is "2 (balance-xor)" or "4 (802.3ad)". Note that
specifying this parameter is available for other "-mode" settings.
L2 Layer2 (Default)
L23 Layer2+3
L34 Layer3+4
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
763
P2X0-1210-05ENZ0