Create Host-Wwn-Name - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create host-wwn-name

create host-wwn-name

This command registers the host alias that corresponds to the WWN (World Wide Name) that identifies FC or
FCoE type HBAs (Host Bus Adapters). Only one WWN can be registered at the same time. The maximum
number of available definitions depends on the number of available host interface ports and the model type.
This enables the alias to be used instead of the numeric WWN when mapping volumes to host servers.
■ Syntax
create host-wwn-name -wwn
[-host-response-number
[-host-group-number
-new-host-group-name
■ Parameter
-wwn
-name
-host-response-number
or
-host-response-name
-host-group-number
or
-host-group-name
wwn
-name
host_response_number
host_group_number
new_host_group_name
This parameter specifies the WWN that corresponds to an HBA. The WWN is a 16-byte
hexadecimal number.
Example: -wwn 40000000abc80e38
wwn
World Wide Name
This parameter specifies the host WWN alias. For details, refer to
(page 23).
name
WWN alias
Optional. This parameter specifies the host response identifier. Two or more parameters
cannot be specified at the same time. For details, refer to
28). If omitted, the existing setting is not changed.
host_response_number
Host response number
host_response_name
Host response name
Optional. This parameter specifies the host group number or the host group name. Only one
host group can be specified at the same time. For details, refer to
(page 30).
host_group_number
Host group number
host_group_name
Host group name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
name
| -host-response-name
host_group_name
| -host-group-name
]
258
host_response_name
]
|
"1.2.5 Alias Name Syntax"
"1.2.13 Host Response Syntax" (page
"1.2.17 Host Group Syntax"
P2X0-1210-05ENZ0