Show Fcoe-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fcoe-parameters

show fcoe-parameters

This command displays the parameters of each FCoE host interface port.
■
Syntax
show fcoe-parameters
■ Parameter
No parameters.
■ Output
Port
Port Mode
Transfer Rate
Frame Size
Host Affinity
Host Response No.
Host Response Name
Reset Scope Range of reset action I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
Reserve Cancel at Chip Reset
FCF VLAN ID FCF VLAN ID Enable/Disable and setting value.
FCF Fabric Name
MAC Address
Each host interface port number
Each port mode (CA)
FC transfer rate (10Gbit/s)
FC frame size (512/1024/2048 byte)
Host affinity mode of each host interface port
Host response number (A hyphen (-) is displayed when the host affinity mode is enabled.)
Host response name (A hyphen (-) is displayed when the host affinity mode is enabled.)
Indicates whether reservations are canceled when a host interface port is reset (Enable:
canceled, Disable: not canceled).
(The setting value is displayed when FCF VLAN ID is enabled)
FCF Fabric Name Enable/Disable and setting value
(The setting value is displayed when FCF Fabric Name is enabled)
MAC address
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
250
P2X0-1210-05ENZ0