Fujitsu Eternus DX100 S3 User Manual page 739

Chapter 7 NAS Function Setting and Display
7.1 Shared Folders > create nas-share
-share
-nfs-allow-host
-cifs-allow-host
Optional. This parameter specifies whether to enable the shared folder that is created. If this
parameter is omitted, "active" is specified.
active The shared folder will be enabled.
inactive The shared folder will be disabled.
Optional. This parameter specifies the host that is allowed to access the shared folder. Multiple
hosts can be specified by inserting a comma (,) between them as a delimiter. If this parameter
is omitted, all of the hosts are allowed access. This parameter can be specified only when NFS
or NFS/CIFS is used as the protocol.
Specify the hosts, including ones that have already been allowed.
The following formats are available:
• single host
Example: 10.123.123.123
• netgroup
Example: @group
• IP network
Example: 10.123.123.0/255.255.255.0
However, the specified string is not checked. Therefore, use of a format other than the above
does not result in an error.
There is no limit on the number of characters (limited by the maximum length, 5,120
characters, of a CLI command.) To delete a setting, specify a null character ("").
allow-host
Host that is allowed to access the shared folder
"" The setting is deleted.
Optional. This parameter specifies the host that is allowed to access the shared folder. Multiple
hosts can be specified by inserting a comma (,) between them as a delimiter. If this parameter
is omitted, all of the hosts are allowed access. This parameter can be specified only when CIFS
or NFS/CIFS is used as the protocol.
Specify the hosts, including ones that have already been allowed.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
739
P2X0-1210-05ENZ0