Fujitsu Eternus DX100 S3 User Manual page 350

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-response
iSCSI Reservation Range
When no parameters are specified, a summary list is displayed.
Host Response No.
Host Response Name
■ Example(s)
The following example displays the details of host response #0:
CLI> show host-response -host-response-number 0
Host Response No.0
Host Response Name
LUN
LUN Addressing
LUN Expand Mode
ALUA
Asymmetric / Symmetric Logical Unit Access
TPGS Mode
TPG Referrals
Inquiry Command
Peripheral Device Type
(Peripheral Device Addressing)
Peripheral Device Type
(Flat Space Addressing)
SCSI Version
NACA
Device ID Type
Product ID
Test Unit Ready Command
Response Status for Reservation
Sense
Change Volume Mapping
Change Volume Capacity
Vendor Unique Sense
Other
Command Monitoring Time
Load Balance Response Status
iSCSI Discovery Reply Mode
iSCSI Reservation Range
The following example lists a summary of all the existing host responses:
CLI> show host-response
Host Response
No. Name
--- ----------------
0 Default
250 Solaris MPxIO
251 HP-UX
252 AIX
253 AIX VxVM
254 VS850/SVC
255 BS2000
iSCSI reservation unit
Host response number
Host response name
350
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Default
Peripheral Device Addressing (Default)
Disable (Default)
ACTIVE-ACTIVE / PREFERRED_PATH (Default)
Enable (Default)
Disable (Default)
No Device Type(3Fh) (Default)
No Device Type(3Fh) (Default)
Version 6 (Default)
OFF (Default)
Type3 (Default)
Default
Normal (Default)
Report (Default)
Report (Default)
Not Report (Default)
25 (Default)
Unit Attention (Default)
Reply all port (Default)
System (Default)
P2X0-1210-05ENZ0