Show Nas-Route6 - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.5 Network Settings > show nas-route6

show nas-route6

This command displays IPv6 route information of the NAS interface.
■
Syntax
show nas-route6 [-mode {current|startup}]
■ Parameter
-mode
■ Output
When the "startup" option is specified:
Destination IP address of the target network or host
Prefix length
Gateway
NAS Interface No.
When the "current" option is specified:
Destination IP address of the target network or host
Gateway
If
Optional. This parameter specifies route information to be displayed.
current The current IP routing table is displayed for each CM.
startup Information is displayed for the static route that is to be specified when the
system starts (default).
Prefix length of the target network
Gateway address
NAS interface name
Gateway address
NAS interface name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
784
P2X0-1210-05ENZ0