Fujitsu Eternus DX100 S3 User Manual page 521

Chapter 5 System Settings and Display
5.2 Network Management > set snmp-view
-include-subtree
-exclude-subtree
■ Example(s):
The following example adds the sub-tree named "1.3.6.1.2.8" to the MIB view named "xview4":
CLI> set snmp-view -view xview4 -subtree2 1.3.6.1.2.8
The following example deletes the sub-tree #1 from the SNMP view named "xview5". For example, sub-tree
#2 is newly relocated as sub-tree #1:
CLI> set snmp-view -view xview5 -subtree1 ""
The following example changes the sub-tree #4 of "xview1" from "include" to "exclude":
CLI> set snmp-view -view xview1 -exclude-subtree 4
Optional. This parameter specifies the "include" subtree type. A value between 1 and 10 can be
specified for the subtree number. Two or more subtree numbers can be specified by separating
them with a comma (,) or a hyphen (-).
If this parameter and the "-exclude-subtree" parameter are omitted, "include" is used as the
default for subtree.
The "-include-subtree" and "-exclude-subtree" parameters cannot both be specified for the
same subtree.
subtree_numbers
"Include" type subtree number
Optional. This parameter specifies the "exclude" subtree type. A value between 1 and 10 can
be specified for the subtree number. Two or more subtree numbers can be specified by
separating them with a comma (,) or a hyphen (-).
If this parameter and the "-include-subtree" parameter are omitted, "include" is used as the
default for subtree.
subtree_numbers
"Exclude" type subtree number
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
521
P2X0-1210-05ENZ0