Fujitsu Eternus DX100 S3 User Manual page 249

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
The following example enables the jumbo frame function on all iSCSI interface ports:
CLI> set iscsi-parameters -port all -jumbo-frame enable
The following example automatically sets the IP address and the gateway IP address to connect to iSCSI
interface port#1 on CM#0 CA#0:
CLI> set iscsi-parameters -port 001 -connect-ip auto -ipv6-gateway auto
Connect Address List :
0. Cancel
1. 2001:1:2:3:4:5:6:7
2. 2002:1:2:3:4:5:6:7
3. 2003:1:2:3:4:5:6:7
4. 2004:1:2:3:4:5:6:7
5. 2005:1:2:3:4:5:6:7
Please specify the number of an address to set up from a Connect Address List.
Input the number (0/1-5)> 2
IPv6 Gateway Address List :
0. Cancel
1. 2001:1000:120::1234:0
2. 2001:1000:120::1234:1111
3. 2001:1000:120::1234:6000
Please specify the number of an address to set up from an IPv6 Gateway Address List.
Input the number (0/1-3)> 2
The following example enables the multiple IP address setting:
CLI> set iscsi-parameters -port 001 -multi-ip enable
The following example enables the information on virtual port #1 of iSCSI port #001, for which the multiple
IP address setting is enabled:
CLI> set iscsi-parameters -port 001 -additional-ip 1 -additional-ip-function enable -ipv4-flag enable -ip
192.168.1.1 -netmask 255.255.255.0
249
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0