Chapter 7 Nas Function Setting And Display - Fujitsu Eternus DX100 S3 User Manual

Chapter 7
NAS Function Setting and Display
This chapter describes the commands that are related to the maintenance of the NAS function.
• The NAS function is not supported by the ETERNUS DX storage systems with a single controller.
• NAS setting related commands are unavailable if one of the CMs in the ETERNUS DX is in abnormal status.
• If an abnormal termination occurs with the configuration command, follow the instructions in the error
message to deal with the issue, and make sure to execute the command again. If the command is not
executed again, the process may not behave normally the next time.
• The NAS function is not supported by the ETERNUS DX200F.
The procedure for creating volumes and making these volumes accessible from a host is provided below.
Procedure
1
Create NAS volumes.
Create Thin Provisioning Volumes for a NAS with the "create volume" command.
When these volumes are created, the following three system volumes are also created:
$SYSVOL1
$SYSVOL2
$SYSVOL3
If system volumes are not created, the NAS function cannot be used.
• To check the status of the volumes, use the "show volumes" command. To change the settings of
an already created volume, use the "set volume" command.
• To delete a NAS volume, use the "delete volume" command.
2
Create NAS shared folders.
Create shared folders for the NAS.
Create NAS shared folders that are configured with Thin Provisioning Volumes for a NAS with the "create
nas-share" command.
• To check the status of the shared folders, use the "show nas-share" command. To change the
settings after a shared folder is created, use the "set nas-share" command.
• To delete a NAS shared folder, use the "delete nas-share" command.
731
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0