Show Radius - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.1 User Management > show radius

show radius

This command displays the settings of the RADIUS server.
■
Syntax
show radius
■ Parameter
No parameters.
■ Output
RADIUS authentication
After error
Primary server
Primary port
Primary port number
Primary authentication mode
Primary shared secret
Primary retry timeout
Secondary server
Secondary port
Secondary port number
Secondary authentication mode
Secondary shared secret
Display the system's mode.
Indicates which method is used after an error is detected.
FQDN or IP address (IPv4 or IPv6) of the primary authentication server.
Port that is used for primary settings.
Port number of the primary authentication server for the authentication protocol
Authentication method type of the primary authentication server
Shared secret of the primary authentication server
Retry timeout value of the primary authentication server
FQDN or IP address (IPv4 or IPv6) of the secondary authentication server
Port that is used for secondary settings.
Port number of the secondary authentication server for the authentication protocol.
Authentication method type of the secondary authentication server.
Shared secret of the secondary authentication server.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
485
P2X0-1210-05ENZ0