Set Ais-Connect - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.2 Network Management > set ais-connect

set ais-connect

This command sets up the AIS Connect operation environment. If the "REMCS function" is running or "E-mail
log send mode" is enabled, the AIS Connect function cannot be enabled.
■ Syntax
set ais-connect
[-function {enable | disable}] [-port {maintenance | remote}] [-send-log {enable | disable}]
[-country-code
[-server-certification {enable | disable}]
[-proxy-server {
[-proxy-type {http | socks}] [-user-name {
■ Parameter
-function
-port
-send-log
-country-code
country-code
]
proxy-server
| ""}] [-proxy-port-number
Optional. This parameter specifies whether to enable the AIS Connect function. If omitted, the
existing setting is not changed.
enabled The AIS Connect function is enabled.
disable The AIS Connect function is disabled.
Optional. This parameter specifies which LAN port is used to communicate with the AIS Con-
nect server. This parameter cannot be specified when the AIS Connect function is disabled. If
omitted, the existing setting is not changed.
maintenance
MNT port
remote RMT port
Optional. This parameter specifies whether to automatically collect logs and send them to the
AIS Connect server when a failure (Error/Warning) occurs. This parameter cannot be specified
when the AIS Connect function is disabled or "Undefined" is displayed for "Service Contract
Responsibility" (the code of the country in which the support office for the ETERNUS DX is
located). If omitted, the existing setting is not changed.
enabled Logs are automatically sent.
disable Logs are not automatically sent.
Optional. This parameter specifies the shipment destination of the ETERNUS DX (the country
where the ETERNUS DX is located). Specify a value that is listed in
parameter cannot be specified when the AIS Connect function is disabled. This parameter must
be specified when the AIS Connect function is enabled. If omitted, the existing setting is not
changed.
country-code
Country code
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
proxy-port-number
user-name
| ""}]
587
]
"Country code list". This
P2X0-1210-05ENZ0