Show Led - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.4 Utility > show led

show led

This command displays the status of the LEDs in each enclosure and each module.
■
Syntax
show led
■ Parameter
No parameters.
■ Output
Controller Enclosure Panel
Controller Enclosure Controller Module
Controller Enclosure Service Controller
Drive Enclosure Panel
Drive Enclosure I/O Module
Drive Enclosure Fan Expander Module
CE-Disk
DE#x-Disk
■ Example(s)
The following example displays the status of the LEDs of all components for the ETERNUS DX100 S3/DX200
S3:
CLI> show led
Controller Enclosure
Panel
Controller Module #0
Controller Module #1
Drive Enclosure #10
Panel
I/O Module #0
I/O Module #1
CE-Disk #0 [ON ] #1 [ON ] #2 [OFF] #3 [OFF] #4 [ - ] #5 [ - ] #6 [ - ] #7 [ - ] #8 [ - ] #9 [ - ] #10[ - ] #11[ - ]
DE#10-Disk #0 [ON ] #1 [ON ] #2 [ON ] #3 [OFF] #4 [ON ] #5 [ - ] #6 [ - ] #7 [ - ] #8 [ - ] #9 [ - ] #10[ - ] #11[ - ]
#12[ON ] #13[OFF] #14[ON ] #15[ON ] #16[ - ] #17[ - ] #18[ - ] #19[ - ] #20[ - ] #21[ - ] #22[ - ] #23[OFF]
LED status of the CE panel-unit
LED status of the CM#x
LED status of the SVC#x
LED status of the DE panel-unit
LED status of the IOM#x
LED status of the FEM#x (The LED state for FEM#1 is shown regardless of the number of CMs)
LED status of the CE-Disk#y
LED status of the DE#x-Disk#y
[OFF]
[OFF]
[ON ]
[OFF]
[OFF]
[OFF]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
711
P2X0-1210-05ENZ0