Fujitsu Eternus DX100 S3 User Manual page 229

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
-rec-transfer-consistency
-rec-transfer-through
-tfo-transfer-mode
-revert-wwn Optional. This parameter is specified when reverting WWPN/WWNN back to the default
■ Example(s)
The following example sets up the parameters to control FC interface port #0 on CM#1 CA#1. Host Affinity
Mode is disabled:
CLI> set fc-parameters -port 110 -host-affinity disable
The following example sets up the parameters to control FC interface port #1 on CM#0 CA#0. The FC port is a
fabric connection:
CLI> set fc-parameters -port 001 -connect fabric
Optional. This parameter specifies the asynchronous consistency mode for the copy transfer
mode. If omitted, the existing setting is not changed. This parameter can only be specified for
the ports that both of the following conditions apply to: the Advanced Copy license has been
registered and the port mode is the RA mode or the CA/RA auto mode.
enable An REC in asynchronous consistency mode is permitted for the target CA port.
disable An REC in asynchronous consistency mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous through mode for the copy transfer mode.
If omitted, the existing setting is not changed. This parameter can only be specified for the
ports that both of the following conditions apply to: the Advanced Copy license has been regis-
tered and the port mode is the RA mode or the CA/RA auto mode.
enable An REC in asynchronous through mode is permitted for the target CA port.
disable An REC in asynchronous through mode is suppressed for the target CA port.
Optional. This parameter specifies the TFO transfer mode (transfer mode of the Storage Clus-
ter). If omitted, the existing setting is not changed. This parameter can only be specified for
the ports that both of the following conditions apply to: the Storage Cluster license has been
registered and the port mode is the RA mode or the CA/RA auto mode.
enable A Storage Cluster transfer is permitted for the target CA port.
disable A Storage Cluster transfer is suppressed for the target CA port.
configuration state after it has been changed by the Storage Cluster. If omitted, the existing
setting is not changed.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
229
P2X0-1210-05ENZ0