Ftrpe Migration - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.4 Flexible Tier Management
3.4.2

FTRPE Migration

This section explains the commands used for FTRPE (Flexible Tier Pool Element) Migration management.
• Checking the FTRPE Migration status
■ Summary of FTRPE Migration settings through CLI
The steps involved in settings the FTRPE Migration using CLI are as follows:
Procedure
1
FTRPE Migration
Use the "show ftrpe-migration" command to check the status of FTRPE Migration.
Only user accounts with the Software role can execute FTRPE Migration. User accounts without the
Software role cannot use the FTRPE Migration function.
FTRPE Migration uses the same session table that is used by RAID Migration, Flexible Tier Migration,
and Thin Provisioning Volume balancing. Since up to only 32 sessions can be registered in this session
table and the ETERNUS DX can have up to 512 FTRPE Migration sessions, other Migration sessions are
in a state of waiting for registration while FTRPE Migration is being executed.
210
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
End of procedure
P2X0-1210-05ENZ0