Fujitsu Eternus DX100 S3 User Manual page 314

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-group
-host-response-number
or
-host-response-name
-name
-add-host-number
or
-add-host-name
or
-release-host-number
or
-release-host-name
■ Example(s)
The following example changes the host group named "HG001". The new name is "NEW_HG002". The host
response number is changed to 2:
CLI> set host-group -host-group-name HG001 -host-response-number 2 -name NEW_HG002
The first command will create the host group named "HG0001". Host numbers 1 and 2 belong to this host
group. The second command will add other definitions to the host group. Host number 3 and host numbers
5 to 7 are specified for the host group:
CLI> create host-group -host-group-name HG0001 -host-number 1,2
CLI> set host-group -host-group-name HG0001 -add-host-number 3,5-7
Optional. This parameter specifies the host response identifier that is to be used to set the host
sense. Only one host response can be specified at the same time. For details, refer to
Host Response Syntax" (page
host_response_number
Host response number
host_response_name
Host response name
Optional. This parameter specifies the new host group name. Only one name can be specified
at the same time. For details, refer to
existing setting is not changed.
host_group_name
Host group name
Optional. This parameter specifies the host that is to be added or deleted. Two or more
parameters can be specified by separating them with a comma (,).
Example: -add-host-number 1,2
For details, refer to "1.2.11 Host Syntax" (page
host_numbers
Numbers of the hosts that are to be added or deleted
host_names
Names of the hosts that are to be added or deleted
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
28). If omitted, the existing setting is not changed.
"1.2.5 Alias Name Syntax" (page
27).
314
"1.2.13
23). If omitted, the
P2X0-1210-05ENZ0